|
|
| Page 1 of 1 |
|
|
 Posted: Wed, 28th Dec 2005 18:55 Post subject: [PS2] Possibilities for SwapMagic on new PS2 Slim without op |
|
 |
hey there ppl,
Now I have my own PS2 Slim Black...
I was looking for SwapMagic, I looked through the instructions on there website
and so on...
They say, that on older PS2 u have to enter Tool C like this:
But my problem is, on my ps2, there is some metal, so, that I cannot stick the tool c in!
The ppl from SwapMagic 3 say, that U have to open the ps2 to remove the metal / build in another tool D! But then I get rid of my warranty!
Anyone knows how to apply the Tool C with the metal or how to make it work, without getting rid of warranties?!
Greets
|
|
| Back to top |
|
|
|
|
| Posted: Thu, 29th Dec 2005 10:32 Post subject: |
|
|
you only void the warrenty on the ps2 if you break the warrenty seal. The warrenty seal on my slimline PSTwo and others that i have encountered ALL have the warrenty seal covering the bottom and the top casing on the back edge in a positon that still is very easy to take PSTwo apart to get inside to either install tool D or install a fliptop (i have done both to PSTwo Consoles), without damaging the seal as when you take it apart the seal stays on the bottom half and top half (open PSTwo like a hinge)
this will leave warrenty intact and looking as if its never been touched
|
|
| Back to top |
|
|
|
|
|
| Back to top |
|
|
|
|
| Posted: Thu, 29th Dec 2005 13:48 Post subject: |
|
|
tried a hairdryer?,
all the PSTWO's i've seen have the sticker on the back edge, these are on new PSTWO either silver of black ones, both the same
|
|
| Back to top |
|
|
|
|
|
| Back to top |
|
|
| Page 1 of 1 |
All times are GMT + 1 Hour |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
Powered by phpBB 2.0.8 © 2001, 2002 phpBB Group
|
|
 |
|
