Coxy use just ur 2 sticks of 2gb to start with, your using same as i had issues with dominator right ? 1066mhz.. you can run that stuff at 2.2v you may have to pump up your MCH/Pci volts as well my board was stock at 1.50v i had it then running with my sticks at 1.54 to get it stable with a o/c on my cpu (e6600/2.4ghz@3.2ghz). I had 4 sticks of 1gb as i said before and it was a no go or the stick/s went duff.. Since fitting Ocz 2*2gb sticks i can run at 1.9v on the ram and just 1.51v on mch/pci ...
Ive always been a big fan of my dominator ram but seems my board isnt a fan of large amounts of it by filling up all the banks.. (aw9dmax)
It will no doubt be a ram issue with vista64 and your board voltages.. Pain in ass that you have not got it sorted, but dont give up, but also at same time dont go overboard with voltage adjustments.. hehe..
Next Time you need hardware, go to alternate in linden. its 55 km from frankfurt. But you can use the autobahn to reach it. Driving around within Frankfurt takes much much longer And alternate has almost anything you need!
Signature/Avatar nuking: none (can be changed in your profile)
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
And alternate has almost anything you need!
